46 lines
1.9 KiB
XML
46 lines
1.9 KiB
XML
<chapter xmlns="http://docbook.org/ns/docbook"
|
||
xmlns:xlink="http://www.w3.org/1999/xlink"
|
||
xmlns:xi="http://www.w3.org/2001/XInclude"
|
||
version="5.0"
|
||
xml:id="ch-file-systems">
|
||
|
||
<title>File Systems</title>
|
||
|
||
<para>You can define file systems using the
|
||
<option>fileSystems</option> configuration option. For instance, the
|
||
following definition causes NixOS to mount the Ext4 file system on
|
||
device <filename>/dev/disk/by-label/data</filename> onto the mount
|
||
point <filename>/data</filename>:
|
||
|
||
<programlisting>
|
||
<xref linkend="opt-fileSystems"/>."/data" =
|
||
{ device = "/dev/disk/by-label/data";
|
||
fsType = "ext4";
|
||
};
|
||
</programlisting>
|
||
|
||
Mount points are created automatically if they don’t already exist.
|
||
For <option><link linkend="opt-fileSystems._name__.device">device</link></option>, it’s best to use the topology-independent
|
||
device aliases in <filename>/dev/disk/by-label</filename> and
|
||
<filename>/dev/disk/by-uuid</filename>, as these don’t change if the
|
||
topology changes (e.g. if a disk is moved to another IDE
|
||
controller).</para>
|
||
|
||
<para>You can usually omit the file system type
|
||
(<option><link linkend="opt-fileSystems._name__.fsType">fsType</link></option>), since <command>mount</command> can usually
|
||
detect the type and load the necessary kernel module automatically.
|
||
However, if the file system is needed at early boot (in the initial
|
||
ramdisk) and is not <literal>ext2</literal>, <literal>ext3</literal>
|
||
or <literal>ext4</literal>, then it’s best to specify
|
||
<option>fsType</option> to ensure that the kernel module is
|
||
available.</para>
|
||
|
||
<note><para>System startup will fail if any of the filesystems fails to mount,
|
||
dropping you to the emergency shell.
|
||
You can make a mount asynchronous and non-critical by adding
|
||
<literal><link linkend="opt-fileSystems._name__.options">options</link> = [ "nofail" ];</literal>.
|
||
</para></note>
|
||
|
||
<xi:include href="luks-file-systems.xml" />
|
||
|
||
</chapter>
|