nixpkgs/nixos/doc/manual/from_md/configuration/ad-hoc-network-config.section.xml

16 lines
647 B
XML

<section xmlns="http://docbook.org/ns/docbook" xmlns:xlink="http://www.w3.org/1999/xlink" xml:id="ad-hoc-network-config">
<title>Ad-Hoc Configuration</title>
<para>
You can use <xref linkend="opt-networking.localCommands" /> to
specify shell commands to be run at the end of
<literal>network-setup.service</literal>. This is useful for doing
network configuration not covered by the existing NixOS modules. For
instance, to statically configure an IPv6 address:
</para>
<programlisting language="bash">
networking.localCommands =
''
ip -6 addr add 2001:610:685:1::1/64 dev eth0
'';
</programlisting>
</section>