nixpkgs/nixos/doc/manual/configuration/ad-hoc-network-config.xml
Mikey Ariel a099ca4505 Chunk NixOS manual
[Squashed commits to make git blame etc. more likely to work. -ED]
2014-08-26 19:03:49 +02:00

24 lines
696 B
XML

<section xmlns="http://docbook.org/ns/docbook"
xmlns:xlink="http://www.w3.org/1999/xlink"
xmlns:xi="http://www.w3.org/2001/XInclude"
version="5.0"
xml:id="ad-hoc-network-config">
<title>Ad-Hoc Configuration</title>
<para>You can use <option>networking.localCommands</option> to specify
shell commands to be run at the end of
<literal>network-setup.service</literal>. This is useful for doing
network configuration not covered by the existing NixOS modules. For
instance, to statically configure an IPv6 address:
<programlisting>
networking.localCommands =
''
ip -6 addr add 2001:610:685:1::1/64 dev eth0
'';
</programlisting>
</para>
</section>